简洁默认

其他 社区

技能解读

当前原文的自动摘译,尚未人工审校。

命令

在 shell 中运行这些命令: Command · Effect concise-default on · 使用上次保存的级别启用。第一次:ultra。 concise-default on lite · 以lite级别启用。 concise-default on ultra · 以ultra级别启用。

行为

on:每一个新的会话都以简洁的active开始;无需手动触发。 off:删除生成的简洁默认值。中途退出:stop concise或normal mode;这不会更改默认设置。已存等级:~/.config/concise/config;在开/关周期中持续存在。写道:

流狐档案 运行与权限由流狐静态检查推断,不代表作者声明或实际测试结果。
领域
通用
作者声明的智能体
未找到明确声明;不据此推断已兼容或已测试
静态检查
88 / 100 · 启发式扫描,不代表运行安全
运行环境证据
未执行;当前没有隔离运行测试证据
作者 / 版本 / 许可证
@tomevault-io · 未声明许可证
上下文用量评级
低消耗
接入复杂程度
需简单配置
是否需要外部接口密钥
不需要
兼容的系统
未声明(默认跨平台)
运行环境要求
未检出明确要求
检测到的文件与系统行为
  • 只读
  • 命令执行
网络行为
仅限本地
安装命令数
无(仅作为资料)

需要注意: 未声明工具权限范围;实际权限由运行环境决定。

作者说明文件(原文) SKILL.md

# Concise Default

Toggle concise mode auto-activation globally. Affects Cursor, Claude Code, and Codex CLI.

## Commands

Run these in shell:

| Command | Effect |
| --- | --- |
| `concise-default on` | Enable with last saved level. First time: `ultra`. |
| `concise-default on lite` | Enable with `lite` level. |
| `concise-default on ultra` | Enable with `ultra` level. |
| `concise-default off` | Disable auto-activation. |
| `concise-default status` | Show current state and level. |

Valid levels: `lite`, `ultra`.

## Behavior

- `on`: every new session starts with concise active; no manual trigger needed.
- `off`: removes generated concise defaults.
- Mid-session exit: `stop concise` or `normal mode`; this does not change the default setting.
- Saved level: `~/.config/concise/config`; persists across on/off cycles.
- Writes:
  - Cursor: `~/.cursor/rules/concise.mdc`
  - Claude Code: `~/.claude/CLAUDE.md`
  - Codex CLI: `~/.codex/instructions.md`

---
> Source: [Cpp1022/concise](https://github.com/Cpp1022/concise) — distributed by [TomeVault](https://tomevault.io).
<!-- tomevault:4.0:skill_md:2026-05-23 -->

讨论

基于 GitHub Discussions。登录 GitHub 即可参与讨论、点赞、订阅更新。